Cobalt Digital Inc 273 CUDDY CABIN, Руководство пользователя

Страница: 80 / 136

Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
3
-
24 276 Owner’s Manual
COBALT
276
BOWRIDER
S
ECTION
3
Check Engine Alarm
Appearance - When the Check Engine Alarm is
received, the LCD display shows “ C E ” flashing.
Guardian Active Alarm
Appearance - When the Guardian Active Alarm is
received, the LCD display shows “ C E ” flashing.
Helm Fault Alarm
Appearance - When the Helm Fault Alarm is
received, the LCD display shows “ H F ” flashing.
2. NAV. LIGHTS - NAV/ANC “ Lights ” - The
NAV/ANC is a three-position switch which activates
the navigational (running) lights and the anchor
light. After installing the light, press the switch
toward the “NAV.” Press the switch toward the
“ANC” and the anchoring/mooring light (360° white)
will illuminate.
Navigational Lights - You must use your
navigational lights (running lights) when operating
your Cobalt boat between sunset and sunrise, and
when daytime visibility is limited. Also, check with
the local authorities before operating your boat for
other requirements concerning the use of
navigational lights.
The navigational lights are identified by a red light
on the port side of the vessel, and a green light on
the starboard side.
Anchor/Mooring Light - All boats at anchor or
moored must display a proper white anchor light.
The anchor light (all-around light) is the white light
located aft of the cockpit. The anchor light must be
visible from 360° and will remain on when operating
the navigational lights.
3. ENGINE HATCH - This switch operates the
electric motor box assembly. Do not continue to
operate the switch when the motor box is closed or
fully open. Lower the motor box support after the
motor box is opened. Be sure to return the support
to its stowed position before lowering the box.
4. STEREO REMOTE CONTROL (standard on
dash, transom mount – optional) -
This panel
provides remote control of the stereo system from
the helm.
5. HEATER (Optional) - This switch operates the
optional cockpit heater blower. It is a four-position
switch: OFF/LOW/MEDIUM/HIGH. Temperature
can be controlled by the switch and by adjusting the
louvered vents. The cockpit heater will only be
effective (warm enough) when the engine is
running at normal operating temperature.
6. SWITCH PANEL
HORN - This switch activates the horn. Press the
switch to activate.
BILGE PUMP - This switch manually controls the
bilge pump.
DOCKING LIGHTS (Optional) - This switch
operates the docking lights.
Docking lights are to be used for docking only. It is
illegal to use your docking lights while cruising.
INTERIOR LIGHTS - This switch provides
illumination within the cockpit area.
STORAGE and ENGINE COMPARTMENT
LIGHTS -
This switch provides illumination within
the storage areas and engine compartment.
CAPTAIN’S CALL (Optional) - This switch
determines the routing of the engine exhaust. In the
ON position, engine exhaust is routed through the
thru-hull pipes. This position produces the most
engine power, but is not acceptable near shore or
on inland lakes and rivers.
In the OFF position, engine exhaust is routed
through the hub of the propeller. This position
releases the exhaust underwater, providing a
quieter engine sound.
NOTICE: Operate the boat
between sunset and sunrise
using your navigational lights.
Navigational lights are legally
required to indicate direction
and right-of-way at night.