WEATHERPAK
®
TRx
USER’S MANUAL
P/N: 0302-109-011 Rev. B
8
VAN MOUNT SETUP
1)
Remove the wind vane from the case. Place the propeller on the front shaft
screw the nut
into place on the propeller shaft to secure the propeller.
2)
Plug the wind vane into the top of the WEATHERPAK
. There is an alignment pin and slot
inside the connector to assure a proper and aligned fit.
Be certain that the wind vane is
plugged all the way in. DO NOT rotate the wind vane when installing or removing.
3)
Align the slot on the WEATHERPAK
with the guide pin on the quick release and push
straight in. (DO NOT “screw” the WEATHERPAK
onto the quick release.) This is a good
sealed fit and may require an extra push - then
push the arms of the clamp down
to assure
a tight fit. DO NOT rotate the WEATHERPAK
or tower when installing or removing.
Also, a series of about 5 beeps, should be heard. (portable tower only)
4)
The WEATHERPAK
is now running and is sampling. When the WEATHERPAK
is
removed from the Quick Release, it will stop sampling and shut itself off.
Figure 5. Van Mount Quick Release
The Van Mount Quick Release is permanently mounted on a vehicle.
Because of the
variability of vehicles, the lower part of this bracket is assumed to be customer furnished.
Coastal supplies the above with 1-½” female SPT.
