Important: Always read and follow operating instructions.
• 9
Description of the Machine Controls
Installation
Space required for positioning
When choosing the place of installation be sure that it
complies with current safety-at-work regulations.
The Tire-Changer must be connected to the main
electric power supply and the compressed air system. It
is therefore advisable to install the machine near these
power sources.
The installation area must leave at least the room shown
in picture “fig. 1”, so as to allow all parts of the machine
to operate correctly and without any restriction.
Lighting should be adequate to perform safe operations
and comply with the current regulations for safety at
work.
Tire-Changer placement and connections
Place Tire-Changer onto a flat, smooth and not slippery floor with a suitable load capacity.
The machine need not necessarily be anchored to the ground, but if you prefer to do so, drill 2 deep holes (100
mm) on the ground in correspondance of 2 holes of the machine rear base by using a 10 mm drill bit of suitable
length. Insert the two brackets A and B into the machine base from the front, and drill two holes
the same as previous ones. Insert suitable metal anchor dowels in the holes drilled and secure firmly.
If the machine is installed outside it must be protected by a appropriate lean-to shed. The installation site should
be equipped with an electrical system with an adequate grounding circuit equipped with an appropriate ground
fault 16A circuit breaker, power indicator light, placed in a visible and accessible place by the operator.
NOTE:
If the machine is supplied without the electrical plug, the user shall install a 20A plug suitable for the
voltage of the machine and complies with current regulations.
Connection to the Compressed Air Supply
The pneumatic supply must be a minimum of 116 psi.
Connect the machine to the compressed air supply by the quick
disconnect located at the rear of the machine (Fig. 2).
Before connecting the machine, ensure pneumatic and electrical supplies meet those indicated
on the machine’s data plate.
•
Even small electrical system jobs must be performed out by qualified personnel.
•
The Manufacturer is not responsible for damages caused by electrical connection different from
those on the machine’s data plate.
•
Unplug the unit from electrical and pneumatic supplies before moving and servicing.
•
During the first connection to the compressed air, attention must be paid to the movement of
certain parts of the machine, which may be sudden and unexpected, creating potential hazards
in the action area.
28”
(70
0mm)