service functions like cleaning or replacing the filter.
Hold Mode will last for 1 hour unless the mode is exited
manually.
To use the Hold Mode press the Warm or Cool button.
While the Temperature is still flashing, press Light
repeatedly until "HOLD" appears in the LCD. Press the
Warm or Cool button to start Hold Mode. Pressing the
Light button or the Warm or Cool buttons will exit this
menu.
Preferences
To enter Preferences press the Warm or Cool button.
While the Temperature is still flashing, press Light
repeatedly until "PREF" appears in the LCD. Use the
Warm or Cool button to enter the menu. Once F/C
appears on the screen you can use the Warm or Cool
button to toggle the selection on the screen or the Light
button to move to the next menu option, option are
listed below. When finished use the light button to save
your selection.
F/C
Change the temperature between Fahrenheit and
Celsius.
24-12
Change the clock between 12 hr and 24 hr display.
RE-- MIN-- DERS
Turn the reminder messages (like “Clean Filter”) On or
Off.
CLN- UP
Cleanup Cycle Duration is not always enabled, so it
may not appear. When it is available, set the length of
time Pump 1 will run after each use. 0-4 hours are
available.
DOL PHIN AD-- DRES --------
(This message may not appear depending on the
configuration). When set to 0, no addressing is used.
Use this setting for a Dolphin Remote which is factory
set for no address by default. When set between 1 and
7, the number is the address. (See the
Dolphin manual for details.)
Utilities and Information
To enter Utilities and Information press the
Warm or Cool button. While the Temperature
is still flashing, press Light repeatedly until
"UTIL" appears in the LCD. Use the Warm or
Cool button to enter “INFO”. While on the
“INFO” press the Warm or Cool button to
enter Utilities and Information or the Light
button to toggle through Addition Utilities.
Utilities and Information
, While “INFO is on
the LCD press the Warm or Cool button and
F/C should appear on the screen. You can
use the Warm or Cool button to toggle the
selection on the screen or the Light button to
move to the next menu option, option are
listed below. When finished use the light
button to save your selection.
INFO (System Information sub-menu)
The System Information Menu displays
various settings and identification of the
particular system. As each item in the
menu is highlighted, the detail for that item is
displayed at the bottom of the screen.
SSID (Software ID)
Displays the software ID number for the
System.
MODL (System Model)
Displays the Model Number of the System.
SETP (Current Setup)
Displays the currently selected Configuration
Setup Number.
SIG (Configuration Signature)
Displays the checksum for the system
configuration file.
Patio—6 Button Topside Upgrade
2021
