Coast Spas Patio Element Bench, Руководство пользователя

Страница: 24 / 37

Main Pump
Auxiliary
Pump Lights
Temperature
PATIO SERIES TOPSIDE CONTROL PANEL
INITIAL START-UP
Your spa will enter Priming Mode (PR) when it is energized.
During Priming Mode, press “Jets” button repeatedly and be sure
the pump is free of air. Priming Mode lasts less than 5 minutes.
Press “Warm” or “Cool” to exit. After Priming Mode, the spa will
run in Standard Mode (see Mode section).
TEMP CONTROL
(80°F - 104°F / 26°C - 40°C) The last measured water
temperature is constantly dis-played. The water temperature
displayed is current only when the pump has been running for at
least 1 minute. To display the set temperature, press “Temp”
once. To change the set temperature, press the temperature
button again before the display stops flashing and hold. The set
temperature will begin to rise, release the but-ton at the desired
set temperature. To decrease the set temperature, press and
hold the “temp” button again and the set temperature will decline,
release at the desired set temperature. After three seconds, the
display will stop flashing and begin to display the current spa
temperature. The spa will then begin heating (or cooling) in
order to reach the set temperature that you have selected.
PUMP
Press “Pump” to turn the pump on or off, and to shift
between low and high speeds (if equipped). If left running,
the pump will turn off after a preset length of time. Low speed
may run automatically at times as part of your spas filtration
cycles, during which it cannot be deactivated from the panel,
however you will still be able to control the high speed setting.
The ozone generator (if installed) will activate anytime low
speed is running.
AUX (PUMP 2)
If an additional pump or blower is installed. Press “Aux” to turn
the device on. If your additional device is a dual speed pump,
pressing “Aux” again will activate the pumps high speed.
Pressing “Aux” again will turn off the device/pump.
LIGHT
Press “Light” to operate the spa light. Turns off after 4 hours.
If your hot tub is equipped with a multicolor lighting package,
then pressing the “Light” button consecutively will toggle the
lights through different colors modes.
MODE
Mode is changed by pressing “Temp” then “Light’. Continue
Pressing the “Temp” then “Light’ button to toggle through the
available modes. Leave the control for 10 seconds to exit.
Standard Mode maintains set temperature. “St” will be
displayed momentarily when you switch into Stand-ard Mode.
Economy Mode heats the spa to the set temperature
only during filter cycles. “Ec” will display when water temp
is not current, and will alternate with water temp when the
pump is running.
Sleep Mode heats the spa to within 20°F/10°C of the
set temperature only during filter cycles. “SL” will dis-play
when water temp is not current, and will alternate with
water temp when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the spa is
energized. The second preset filter cycle begins 12 hours
later. Filter duration is programmable for 1, 2, 3, 4, 5, 6, 7, or
8 hours. The default filter time is 1 hour. To program, press
“Temp,” then “Jets.” Press “Temp” to adjust. Press “Jets” to
exit programming.
2 4
OWNER’S MANUAL
2022
PATIO S ERIES