Coast Spas LUXURY 2022 Series, Руководство пользователя

Страница: 26 / 49

2 6
OWNER’S MANUAL 2022
LUXURY SPAS
If the Spa has a Circ Pump, a Circ Pump Icon will appear to
indicate its activity, but outside of Priming Mode, the Circ Pump
cannot be controlled directly.
Note: The icon for the pump that is associated with the heater
(Circ or P1 Low) will have a red glow in the center when the heater
is running.
Settings
The Settings Screen is where all programming and other spa
behaviors are controlled. This screen has several features that can
be acted on directly. These features may include Temp Range,
Heat Mode, Hold, and Invert Panel. When one of these items is
selected, it will toggle between two settings. All other menu items
(with an arrow pointing to the right) go to another level in the menu.
Dual Temperature Ranges (High vs. Low)
This system incorporates two temperature range settings with
independent set temperatures. The specific range can
be selected on the Settings screen and is visible on the Main
Screen in the upper right corner of the display. These ranges
can be used for various reasons, with a common use being a
“ready to use” setting vs. a “vacation” setting. Each range
maintains its own set temperature as programmed by the user.
This way, when a range is chosen, the spa will heat to the set
temperature associated with that range.
•
High Range can be set between 80°F and 104°F.
•
Low Range can be set between 50°F and 99°F.
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate
water through the heater. The pump that performs this function is
known as the “heater pump.” The heater pump can be either a
2-speed pump (Pump 1) or a circulation pump. If the heater
pump is a 2-Speed Pump 1, Ready Mode will circulate water
every 1/2 hour, using Pump 1 Low, in order to maintain a
constant water temperature, heat as needed, and refresh the
temperature display.
This is known as “polling.” Rest Mode will
only allow heating during programmed filter cycles. Since
polling does not occur, the temperature display may not show
a current temperature until the heater pump has been running
for a minute or two. When the heater pump has come on
automatically (for example for heating) you can switch between
low speed and high speed but you cannot turn the heater pump off.
Restricting Operation
The control can be restricted to prevent unwanted use or
temperature adjustments. Locking the Panel prevents the controller
from being used, but all automatic functions are still active. Locking
the Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted.
Settings Lock allows access to a reduced selection of menu items.
These include Filter Cycles, Invert, Information and Fault Log. They
can be seen, but not changed or edited.
The Lock option can be accessed from the
“Settings” menu.
Unlocking
The same steps are used to Lock and Unlock. To lock either
Settings or Panel first select Settings (if it says “Unlocked”) or
Panel (if it says “Unlocked”), than press the word “Lock“ for at least
5 seconds. To unlock either Settings or Panel first select Settings
(if it says “Locked”) or Panel (if it says “Locked”), than press the
word “Lock“ for at least 5 seconds.