Coast Spas 1600, Руководство пользователя

Страница: 29 / 66

OWNER’S MANUAL
SWIM SPAS
2021
2
9
INITIAL START-UP
Your swim spa will enter Priming Mode (PR) when it is
energized. During Priming Mode, press “Jets” button repeatedly
and be sure the pump is free of air. Priming Mode lasts less than
5 minutes. Press “Warm” or “Cool” to exit. After Priming Mode,
the swim spa will run in Standard Mode (see Mode section).
TEMP CONTROL
(80°F - 104°F / 26°C - 40°C)
The last measured water temperature is constantly displayed.
The water temperature displayed is current only when the pump
has been running for at least 1 minute. To display the set
temperature, press “Temp” once. To change the set temperature,
press the temperature button again before the display stops
flashing and hold. The set temperature will begin to rise, release
the button at the desired set temperature. To decrease the set
temperature, press and hold the “temp” button again and the set
temperature will decline, release at the desired set temperature.
After three seconds, the display will stop flashing and begin to
display the current swim spa temperature. The swim spa will
then begin heating (or cooling) in order to reach the set
temperature that you have selected.
PUMP
Press “Pump” to turn the pump on or off, and to shift between
low and high speeds (if equipped). If left running, the pump will
turn off after a preset length of time. Low speed may run
automatically at times as part of your spas filtration cycles, during
which it cannot be deactivated from the panel, however you will
still be able to control the high speed setting. The ozone
generator (if installed) will activate anytime low speed is running.
AUX (PUMP 2)
If an additional pump or blower is installed. Press “Aux” to turn
the device on. If your additional device is a dual speed pump,
Main Pump
Auxiliary Pump
Lights
Temperature
pressing “Aux” again will activate the pumps high speed.
Pressing “Aux” again will turn off the device/pump.
LIGHT
Press “Light” to operate the swim spa light. Turns off after 4
hours. If your swim spa is equipped with a multicolor lighting
package, then pressing the “Light” button consecutively will
toggle the lights through different colors modes.
MODE
Mode is changed by pressing “Temp” then “Light”. Press the
“Temp” button to toggle through the available modes. Press
“Light” to exit programming.
Standard Mode maintains set temperature. “St” will be
displayed momentarily when you switch into Standard Mode.
Economy Mode heats the swim spa to the set temperature
only during filter cycles. “ Ec” will display when water temp is not
current, and will alternate with water temp when the pump is
running.
Sleep Mode heats the swim spa to within 20°F/10°C of the
set temperature only during filter cycles. “SL” will display when
water temp is not current, and will alternate with water temp
when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the swim spa is
energized. The second preset filter cycle begins 12 hours later.
Filter duration is programmable for 1, 2, 3, 4, 5, 6, 7, or 8 hours.
The default filter time is 1 hour. To program, press “Temp,” then
“Jets.” Press “Temp” to adjust. Press “Jets” to exit programming.
SWIM SPA POOL SERIES CONTROL PANEL