G a m e D a y G u i d e
205 Technology Parkway
Auburn, Alabama 36830
www.coachcomm.com
Phone 1.800.749.2761
Fax 1.888.329.2658
While CoachComm makes every attempt to maintain the accuracy of the information contained in this document, this information is subject to change without notice.
Please check our website for the latest system specifications and certifications. Copyright © 2018 CoachComm LLC. All rights reserved. The X-System logo is a
trademark of CoachComm LLC. All other trademarks are property of their respective owners. Document Reference: 2018.02 D0000384_A
Once your game has ended, power off and properly stow away all components:
6a. Power off all RPs and stow them with the field headsets in the sideline case.
6b. Power off and disconnect all Wired BeltPacks and stow them in the press box case.
6c.
Power off the CU and disconnect the Cat 5 cable between the Press Box Rack Unit and the antennas. Carefully disassemble
and stow the antennas and mounting hardware in the appropriate case.
6d. Coil all cables and stow them with the press box headsets in the accessory case.
6e. Disconnect power from the Press Box Rack Unit and stow it in the press box case.
Important:
Thoroughly dry off any moisture prior to storage. Failure to do so can cause components to corrode and damage.
Power off and stow away.
6
Power on and walk test Radio Packs.
8
(5b.) Turn on by
holding Power button
for 3 seconds.
(5a.) Install battery.
5
The procedures in this step should be performed with at least two people.
5a.
On the sideline, unpack the sideline case and install one of the provided, fully
charged Lithium-Polymer rechargeable batteries or three AA batteries in each
Radio Pack (RP).
5b. Power on the first two RPs by pressing and holding the Power button on the
back of the RP for 3 seconds.
5c.
Confirm each RP is on the same conference, connect a headset to each RP,
and conduct a walk test to confirm their operation. The RP’s LQ value can be
used to gauge performance. See the
X-System Operating Manual
for more
information about LQ values.
Important:
Each tester should walk their Wireless RPs to opposite goal lines and
back, ensuring clear communication between all Wireless RPs. Always
place the Wireless RP on the hip opposite from the press box when walk
testing.
5d.
After walk testing is complete, place the RP down on a table or bench. Be sure
to place each RP a foot or so apart; bunching RPs together could impact
wireless performance. Repeat steps 5b-5c for each of the remaining RPs.
Important:
If raining, cover the RPs or return them to their cases.
5e. Confirm communication between wireless and wired coaches.
(5c.) Check LQ.
