G a m e D a y G u i d e
1
1a. Unpack
the press box and accessory cases.
1b. Position the Press Box Rack Unit out of the way to avoid coaches and other traffic.
1c. Connect power to the Press Box Rack Unit, but do NOT turn on the Control Unit (CU) yet. The
“Power” LED on the front of the Wired Interface should be lit green.
Important:
X-System requires a minimum of one dedicated 15 amp 120V circuit.
Set up Press Box Rack Unit.
Mount and connect the Antenna.
2a.
Using either the clamp or suction cup mounting hardware, secure the antenna bracket so that the antenna’s logo points
toward the center of your team’s coaches’ box.
Note:
Any obstructions between
the antenna and field
(like window tinting)
can negatively impact
performance. CoachComm
recommends opening
windows or mounting
the antenna externally to
the press box. We also
recommend covering
antennas with a clear
plastic bag or a rain cover
in the event that rain is expected.
2b.
Connect a Cat 5 cable to the X-NET IN port on the antenna.
2c. Connect the other end of the Cat 5 cable to the FIELD ANTENNA port on the Press Box Rack Unit’s rear panel.
2d. If using a second field antenna, confirm the short Cat 5 cable is properly connected between the first antenna’s RT LOOP
port and the second antenna’s X-NET IN port.
Note:
If applicable, a third antenna for booth wireless can be connected as outlined in the diagram below.
CAUTION:
Secure and protect any cords to prevent walkway hazards and potential contact with moisture.
50
40
40
50
40
40
50
40
40
50
40
40
Your Sideline
Your Sideline
OR
2
First Field Antenna
Second Field Antenna
Optional Booth Antenna
Pressbox
Rack Unit
(1c.) Power LED
Cables not shown
