7
S e t u p a n d T e a r d o w n P r o c e d u r e s
Tempo Go
3. Place the Tempo Control Unit onto the mounting bracket. Be sure to align the holes in the Control Unit mount and
bracket. Use one of the provided pins to secure it in place as shown in Figure 9.
4. Place the two speakers atop the bracket posts on each side of the Control Unit as shown in Figure 10.
5. Connect the 6-pin ends of the two audio cables to the “LEFT” and “RIGHT” ports on the rear of the Control Unit. Then,
connect the 3-pin ends to the “MIC/LINE IN A” ports on the rear of each speaker. (The audio cables are yellow in Figure
11.)
6. Verify that the speakers’ settings are as
follows:
• LF: DEEP
• HF: FLAT
• Front LED: PWR
• Mic/Line in A: LINE
• Gain A: 0 dB
• Gain B: 0 dB
Note:
See page 10 for information
about connecting an optional
Tempest
®
FX system.
7. Connect the Control Unit’s power cable and the two speakers’ power cables into a power strip. (The power cables
are red in Figure 11). Then, connect the power strip (via extension cord if necessary) to a 120 Volt 15 Amp power
source.
Note
:
If you are using an optional Tempest FX system with Tempo Go, CoachComm recommends that you
power on your FX system before powering on your Tempo Go Control Unit and speakers. See page
10 for information about connecting an optional Tempest
®
FX system.
CAUTION:
Protect the power cords from foot or vehicle traffic. Do not allow Tempo Go cords to become
pinched or crimped, particularly where plugs enter power receptacles and/or where they exit from the unit.
8. After your event, do the following:
• Turn off each Tempo Go product. To properly turn off the Tempo Control Unit, the user should hold down the
top four (4) buttons simultaneously until the clock display LEDs turn off. At this point, the power cable can be
disconnected from the Tempo Control.
• Disconnect all audio devices.
• Disconnect and secure audio and power cables.
• Disassemble the Control Unit, speakers, bracket, and tripods, and place them in their case and bags.
Figure 9: Control Unit Secured to Mounting Bracket
Figure 10: Speakers Placed Atop Mounting Bracket
Figure 11: Tempo Go Audio Cables (Yellow) and Power Cables (Red)
Содержание Tempo Go
Страница 1: ...O p e r a t i n g M a n u a l ...
Страница 4: ...ii T a b l e o f C o n t e n t s Tempo Go This page is intentionally blank ...
Страница 34: ...30 P r o d u c t S u p p o r t a n d W a r r a n t y Tempo Go ...
Страница 35: ...31 P r o d u c t S u p p o r t a n d W a r r a n t y Tempo Go ...
