CO/Tech YLQ22SH-150, Оригинальное руководство пользователя, Страница: 6 / 48

6
EN
GL
IS
H
9
5
3.2 Preparations for use
Check that all the parts are intact and that nothing is missing.
Caution:
Turn off the pressure hose and pull the plug from the socket when servicing
and adjusting the machine.
1. Check that the power switch is in the
0 position.
2. Grab the centre of the hose reel’s handle and pull outwards to unlock the reel,
then wind out the hose.
3. Connect the pressure hose (6) to the outlet connection (3).
4. Connect the pressure hose (6) to the pistol grip (5).
5. Connect the pistol grip (5) and lance (9) by pushing it into the lance (9) with
the bayonet connection on the pistol grip (5) and turn it clockwise until it locks.
Do this before attempting to use the pressure washer.
Caution: Make sure that the nozzle is
securely fastened onto the lance other-
wise it can be shot from the lance with
extreme force. The above description
even applies for the detergent tank
and car wash brush with adaptor
connected.
6. Connect a garden hose (not included) between the water tap and the machine’s
inlet connection (4), using either a threaded or quick connection. The water inlet (4)
is already equipped with a filter from the manufacturer to remove any dirt, sediment
and other contaminants which can damage the washer.
7. Pull the trigger, releasing any possible air until water begins flowing.
Caution: The temperature for the water supply must not exceed 40 °C.
Run the hose for a moment if the hose has sat in the sun and become warm.
The pressure hose must be operated in an upright/vertical position. It must not
be used in the lying/horizontal position.
Caution: Make sure that no bystander or pet is within a 15 metre risk zone from
the nozzle before continuing assembly.
8. Make sure that the garden hose used is undamaged and securely connected at
both ends. Open the water tap completely (or as much as needed to supply
the pressure washer).
9. Connect the lead’s plug to a wall socket, press the trigger (7), point the lance
towards a risk-free direction and turn on the motor with the power button (1).
• If the water supply is from a tank or similar source without pressure, both the pump
and the inlet hose must be filled with water before the pump is started.
The tank must be placed at higher level than the pressure washer. If the water has
contaminants or is cloudy an inlet filter must be mounted to the hose inlet.
•
N.B.
The recommended distance between the nozzle and the surface to be
cleaned is approx. 30 cm. Shorter distances produce a higher degree of cleaning
power on the surface to be cleaned. A longer distance produces a gentler cleaning
for sensitive surfaces.