CO/Tech S1J-AJ8-10, Инструкция по эксплуатации

Страница: 2 / 24

2
EN
G
LI
S
H
Engraving Tool
Art.no: 18-3028 Model: S1J-AJ8-10-UK
30-9128 S1J-AJ8-10
Please read the entire instruction manual before using and save it for future use.
We apologise for any text or photographic errors and any changes in technical
data. If you have any questions concerning technical problems please contact our
Customer Service Department (see address on reverse.)
Safety Warnings Common for grinding,
sanding, wire brushing, polishing or abrasive
cutting-off operations
a) This power tool is intended to function as a grinder, sander, wire brush
or cut-off tool. Read all safety warnings, instructions, illustrations
and specifications provided with this power tool. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury.
b) Operations such as polishing are not recommended to be performed with
this power tool. Operations for which the power tool was not designed may
create a hazard and cause personal injury.
c) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can
be attached to your power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. accessories running faster than their rated
speed can break and fly apart.
e) The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot
be adequately guarded or controlled.
f) The arbour size of wheels, flanges, backing pads or any other accessory
must properly fit the spindle of the power tool. Accessories with arbour
holes that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks,
tear or excess wear, wire brush for loose or cracked wires. If the power
tool or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and run the power