cnsat Smart Antenna Selector, Инструкция по эксплуатации

Страница: 10 / 14

So, if you need to change the IP address of the CPU (of course is the IP address of the S.A.S.
Itself), you have to be sure about the parameters to insert. If you set something wrong or an IP
which is no more reachable from your network, the only was to come back is to use the USB
interface and Crestron Toolbox.
To set new values for CPU, just click on “New” button of one ot the fields and wait until you can
see the blue cursor on the first number. After that use the cursor to change the values and at the end
click on “Submit” button. After clicking submit be absolutely sure that the values are correct and
click on “Apply”. This button reboot the system so the interface cannot be more used for around
five minutes.
After that time, open again the .exe file of the Windows PC GUI and replace the old IP address with
the one you set before. If you did everything correct you will see again the GUI. If not you need to
check your network and if you cannot find the S.A.S. you need support from a Crestron Technician
to restore a factory configuration.
Once you open again the Windows PC GUI and the processor is still initializing you can see this
page:
After the wait time, which is around one minute you can access again the GUI.