Classification
Page
Operation, technical
and maintenance
manual
Unclassified
8 (14)
Date
2008-01-11
Document No.
Issue
CNSS-05-1187
E
_______________________________________________________________________________________________________________________________________________
This document and attachments shall remain our property. They may not without our written consent, either in their original state or with any changes, be copied or reproduced,
disclosed to or delivered to anyone unauthorized nor used for other purposes than what has been confirmed by C.N.S. Systems AB in writing.
BL0004E
4
SETTING TO WORK
When the VDL 6000/FASS is installed in compliance with the Installation manual the following setting-to-work procedures
shall be performed.
4.1
Initial settings
Before starting the VDL 6000/FASS some initial settings need to be checked/adjusted. The following items shall be
checked/adjusted:
4.1.1
Ground connection
Check that the VDL 6000/FASS is connected to the ground plane of the building as described in the Installation manual.
Connection of the Ground Bolt is a mandatory procedure and shall be done before connecting
any other cables to the VDL 6000/FASS
4.1.2
Input power
Check that the VDL 6000/FASS is connected to the main power supply as described in the Installation manual.
4.1.3
Antenna connections
Check that the GPS antenna cable is connected to the VDL 6000/FASS as described in the Installation manual.
Check that the VHF antenna cables are connected to the VDL 6000/FASS as described in the Installation manual.
The VDL 6000/FASS Base station operates in simplex mode.
4.2
Configuration
Configuration of the VDL 6000/FASS shall be done according to the Monitor and control tool manual. For specific details
of configuration, VDL reservations, messages, etcetera please advice IEC 62320-1.
