User’s Manual
Page 4
7.
Test the E-Stop by opening the circuit a confirming the green LED goes off. You can now
enable back on the SCHP by moving (JUMPER=ON) so it will be UCCNC what will enable
the system. You should get the green LED while the e-stop switch is closed and UCCNC is
active.
•
If something is not clear, do not hesitate in opening a support ticket and we will get back to
you as soon as possible:
Disclaimer:
Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC nor Arturo
Duncan is liable for any accidents resulting from the improper use of these devices. This product
is not a fail-safe device and it should not be used in life support systems or in other devices where
its failure or possible erratic operation could cause property damage, bodily injury or loss of life.
