CML Top Gun Heli-Flite Orbiter, Инструкция по эксплуатации

Страница: 8 / 20

8
The receiver aerial is supplied coiled up around the
skid type undercarriage.
It must be unwound and fully extended before
attempting to fly.
Failure to do so could result in loss of control and a
crash.
Fully extend the aerial and thread through the
fuselage.
REMOVE THE FUSELAGE NOSE CONE.
Carefully pull on each side of the fuselage at the
retaining bar and grommets.
With the grommets clear of the retaining bar, the
nose cone will slide off the front of the model.
SECTION 4: FINAL SET UP
SWITCH ON TRANSMITTER.
Check that rudder, elevator and aileron trims and
sticks are central
and that throttle
trim and stick is
fully down.
Connect the
battery to the
ESC lead.
INSTALL THE CHARGED LIPO BATTERY INTO
THE FUSELAGE.
It locates in a cradle positioned at the bottom of the
chassis.
It’s position should be adjusted to give correct
balance.
Position the fly bar on the top rotor at 90 degrees to
the fuselage.
Support the helicopter off the fly bar weights and
check the balance, the model should hang level.
Adjust the battery position forwards or backwards
to suit.