CMi RoboPro CE5000-40-CRP:, Руководство пользователя

Страница: 3 / 23

RoboPro CE5000-40-CRP : CMi User Manual 2010
Last Update : March 25, 2011
CMi / J. Pernollet 3/23
•
Raise the media set lever and turn on the RoboPro power. A message
appears on the control panel screen of the RoboPro.
- If the “ REALIGN ROLLERS ” message is displayed, one (or both) of the push rollers
is not correctly positioned. Check it again.
- Pressing the up and down arrow keys on the front panel displays “ ROLL1 PRESS
ENTR”, “ROLL2 PRESS ENTR” and “SHEET PRESS ENTR” .
Select “ SHEET […] ” when using a sheet or “ ROLL1 […] ” or “ ROLL2 […] ” when
using a roll.
Note: “SHEET […]” and “ROLL1 […]” set the corner of the medium as the origin
point (automatic detection of front and rear edges). “ROLL2 [..]” sets the current
setting position as the origin point.
Setting the cutting conditions
•
Using the arrows of the front panel, move the cutter pen to the position where
you want to initiate the test. You can use the “ORIGIN” button to set this
particular point as the origin.
•
Press the “COND.” key and set your parameters using the arrows keys (refer
to table here below). Adjust the cutting force so that the cutting trace lightly
appears on the media backing sheet.
Optimal cutting conditions for each media type