CMi RoboPro CE5000-40-CRP:, Руководство пользователя

Страница: 2 / 23

RoboPro CE5000-40-CRP : CMi User Manual 2010
Last Update : March 25, 2011
CMi / J. Pernollet 2/23
Preparing the blade
TO AVOID INJURY, ALWAYS HANDLE THE CUTTER
BLADE WITH CAUTION
Adjust the blade length by turning the blade-length adjustment knob. Turn the knob
clockwise to extend the blade or counter-clockwise to retract the blade. When the
knob is turned by one scale unit, the blade moves approximately 0.1mm (knob full
turn = 0.5mm).
If the blade is extended too far in relation to the thickness of the medium being cut, it
will damage the cutting mat. Assuming that the medium thickness is
‘ t ’, the blade
length ‘
l
’ should be equal or slightly greater than ‘ t ’. Make sure ‘
l
’ is never greater
than the combined thickness of the medium and its backing sheet.
Note: if it is not possible to accurately determine the medium thickness, adjust the
blade length by gradually increasing it until only traces of the blade appear on the
backing sheet after a cutting test conducted.
Loading a medium
•
Lower the media set lever to raise the push rollers.
•
Pass the medium through the RoboPro and align it with the guide lines
engraved on the machine. Make sure the medium passes over the media
detecting sensor.
•
Adjust the push rollers position to the blue guide marks so medium can be fed
to the machine (see next page) (CAUTION: be sure the media set lever is
lowered).