CMC Typhoon Tower, Руководство пользователя

Страница: 8 / 13

Tighten the 3/8”-16 x1”socket head cap screws on the header down snug but
moveable just to hold the tubes in place while the tower is lifted onto the boat
(Fig. 14). Remove the two 3/8”-16 X ¾” socket button head cap screws from
each of the starboard rear brace clamp and starboard front clamp. Then mount
the brace plate over lapping the brace clamps on the outside of the tower as
shown in Fig. 15. Follow the same procedure to mount the other brace plate to
the port side.
FIG. 14 FIG. 15
To mount the wakeboard racks, first remove the ½”-13 X ¾” socket button head
cap screws from the wakeboard racks as shown in Fig 16. Mount the wakeboard
rakes through the pre-drilled holes in the port and starboard brace plates of the
tower as shown in Fig. 17. Make sure they are positioned to slant slightly upward
as shown.
FIG. 16 FIG. 17
MOUNTING THE TOWER TO THE BOAT
STEP 2:
Decide where you want to mount the tower on the boat, within min.
and max. dimensions shown in diagram 2, and mark the location to drill the
holes. The first holes to be drilled into the boat for mounting will be the aft holes
to mount the clevis feet of the port and starboard rear tube assemblies. The
fiberglass that you are going to drill these mounting holes through must be a
8