CMC Typhoon Tower, Руководство пользователя

Страница: 5 / 13

ASSEMBLY OF TOWER
STEP 1:
First, remove the panel from the bottom of the header assembly as
shown in Figs. 1 & 2. Next wire the tower for the navigational light that will be
located at the top of the pedestal of the header. You will need to decide if you
will want to detach the back of the tower to tilt it forward for storage or detach the
front of the tower to tilt toward the back for storage. You will want to run the wire
cable through one of the tubes that pivots that is nearest where you want to
connect to a switch for the light. This particular boat owner wants to tilt the tower
forward when storing his boat in the garage. Therefore, wiring for the
navigational light will need to be through one of the front tubes nearest his
switch. For this boat it will be the front starboard side.
FIG. 1 FIG. 2
Take one end of the 20’ 18-4 shielded wire cable that was included with the
tower and run it through the pedestal as shown in Fig. 3. Locate the black and
red wires and cut back the insulation to the bare wire as shown. The other two
wires within the cable (green and white) can be used for speakers and other
lights if desired. Now take the other end of the wire cable and run it through one
of the pre-drilled holes in the bottom of the header as shown in Fig. 4.
FIG. 3 FIG. 4
5