english -
27
R
espresso coffee machine - technician instructions
16. PREPARATION OF HOT BEVERAGES
16.1 MANUAL DISPENSING OF HOT WATER
Place the cup under the hot water nozzle
(2)
and turn the tap knob
(1)
counterclockwise:
the steam hot water coming out of the nozzle will be proportional to the opening of the tap. to
interrupt the hot water dispensing turn the knob clockwise
(1)
.
16.2 AUTOMATIC HOT WATER DELIVERY
Programming
• place the programming lever
(4)
in the ON position. It is located under the front right-
hand panel of the body (in some versions to start operating it will be sufficient to turn
the programming key or hold down the PROG/STOP
(5)
key for 5 seconds);
• Put the cup under the hot water spout
(2)
;
• press the PROG/STOP button
(5)
of the first right-hand push-button panel; all the dose
button LEDs will come on;
• press the hot water delivery key
(3)
;
• upon reaching of the desired serving, confirm pressing the key
(3)
again;
• to exit programming press the PROG/STOP key
(5)
;
• upon completion of programming, place the programming lever
(4)
back in the OFF position.
16.3 DISPENSING STEAM
To dispense steam, turn the tap knob
(6)
counter-clockwise: the steam coming out of the
nozzle
(7)
will be proportional to the opening of the tap.
ATTENTION
Carefully move the steam nozzle with the anti-burn nozzle
(8)
and do not touch
the hot water nozzle: contact with the hot water and steam may be harmful to
individuals, animals or property .
2
1
3
STOP
PROG.
5
4
6
7
8
Dispensing hot water
• Put the cup under the hot water spout
(2)
;
• press the hot water key
(3)
: wait for the delivery of water;
• To stop delivery in advance, press the hot water dispensing key again
(3)
.
17. CUP HEATING DEVICE
The cup heating device is for heating cups before they are used:
• Place the cups on the upper surface
(1)
of the coffee machine;
• Start the electric heating element with the switch
(2)
or, for some models, with
the push button panel.
1
2
ATTENTION
For safety reasons we advise against putting cloths or other objects
on the upper surface of the machine as they could obstruct normal
air circulation.
