Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 387 / 548

UNITIZED TRANSAXLE (GASOLINE VEHICLE) Unitized Transaxle Installation
24
Club Car
587
Figure 24-43 Driven Clutch and Key
588
Figure 24-44 Snubber and Bracket
13. Position the floor jack under the rear frame crossmember and raise the jack high enough to support the vehicle
(Figure 24-45, Page 24-19) . Make sure the vehicle is stable on the jack, then remove the jack stands.
14. After the jack stands are removed, lower the vehicle to approximately its normal height. Position the leaf springs
in the front spring mounts and install the bolts and lock nuts. Ensure the brackets on the brake cables are placed
over the bolts before the lock nuts are installed. Tighten to 15 ft·lb (20.3 N·m).
15. Adjust the vehicle height with the floor jack to position the leaf springs for mounting in the shackles. Install the
mounting bolts and lock nuts (Figure 24-46, Page 24-19) . Tighten lock nuts to 18.5 ft·lb (25 N·m).
2409
Figure 24-45 Leaf Springs
2701
Figure 24-46 Leaf Springs and Shackles
16. Position shocks in the shock mounts and install cushions, mounting washers and nuts (Figure 24-47, Page
24-20) . Tighten nuts until cushions expand to be the same diameter as the mounting washers.
2014 Precedent ® Golf Car Maintenance and Service Manual Page 24-19