Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 388 / 548

24
Unitized Transaxle Installation UNITIZED TRANSAXLE (GASOLINE VEHICLE)
17. Connect brake cables. See Brake Cable Installation on page 6-14.
18. Route the engine kill switch wire (18-gauge white/black) through the same retainers that hold the accelerator
cable. Connect the wire to the bullet connector at the lower right front of the engine (Figure 24-48, Page 24-20) .
767
Figure 24-47 Shock Absorber
569
Figure 24-48 Ignition Kill Wire
19. Connect the oil level sensor wire (18-gauge yellow) to the jumper wire (Figure 24-49, Page 24-20) .
20. Connect the 6-gauge white wire to the F2 post, the 6-gauge black ground wire to the A2 post and tighten both
wires to 48 in·lb (5.4 N·m). Connect the 16-gauge yellow wire to the DF post on the starter/generator and
tighten to 30 in·lb (3.4 N·m)
(Figure 24-50, Page 24-20) .
DF
F2
DF
1
2
3
1. Yellow Wire 2. White Wire 3. Ground Wire at A2 Terminal
568
Figure 24-49 Oil Level Sensor Jumper wire
1350
Figure 24-50 Starter/Generator – Model 114-01-4005
shown
21. Route shifter cable through the shifter cable bracket. Ensure the cable boot is properly positioned through the
bracket. The clips on the boot should hold the cable in place. Connect shifter cable rod end to the shifter
arm
(Figure 24-51, Page 24-21) .
22. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in·lb
(5.7 N·m) (Figure 24-52, Page 24-21) .
Page 24-20 2014 Precedent ® Golf Car Maintenance and Service Manual