Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 60 / 344

WHEEL BRAKE ASSEMBLIES Rear Brake Cables
Page 6-14 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
6
Front Brake Cable Installation, Continued:
10. Tighten the wire tie (1) above the shock tower (8) until the cables between the front brakes and the
cable clamps are aligned with the back of the shock tower as shown (Figure 6-21, Page 6-13).
11. To prevent cables from kinking, pull the front brake cables toward the rear of the vehicle.
12. Install a wire tie (16) to secure the brake cables to the driver side I-beam as shown (Figure 6-22, Page
6-14). See following NOTE.
NOTE: Make sure brake cables are clear of the tie rod and do not hang below the bottom of the frame.
13. Trim excess material from the wire ties.
14. Adjust brakes. See Brake Adjustment on page 6-16.
REAR BRAKE CABLES
Read WARNING on page 6-1.
REAR BRAKE CABLE REMOVAL
1. Chock the wheels and release the park brake.
2. Loosen equalizer retaining nuts (1) on equalizer rod (2) to slightly loosen brake cables (3) (Figure 6-23,
Page 6-15).
3. Rotate brake cables upward and pull ends through holes in top of equalizer.
Figure 6-22 Secure Cables to I-beam
16