Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 177 / 280

S10 FE350 FUEL SYSTEM Carburetor
15
8. Select the proper size main jet. See Main Jet Elevation/Size Chart on page 15-3. Check the size designation
on the jet to make sure it is the correct part.
9. Install the new main jet and tighten it to 12 in-lb (1.4 N·m). See following CAUTION and NOTE.
CAUTION
• Do not remove the valve/spring assembly from the float assembly. Doing so will damage the spring.
NOTE: Inspect the main jet nozzle (7), and pilot jet (4) to ensure they are free from contamination (Figure 15-4,
Page 15-4) . Replace any part that is clogged with contamination. Replace the float if it is damaged, or
if the float valve is damaged or worn. Examine the float valve/spring assembly to make sure the spring is
installed correctly
(Figure 15-5, Page 15-5) .
10. Install the fuel bowl. Make sure that it is positioned properly by aligning the marks applied in step 4. See
following CAUTION.
CAUTION
• Make sure the fuel bowl is properly seated against the carburetor fuel bowl gasket, and the gasket
is not pinched.
1
4
5
1
3
2
1. If spring looks like this... 2. then adjust spring to look like this by... 3. holding float firmly and rotating valve counterclockwise to seat
spring in seat of float bowl 4. Check for coil located in groove above both ears. 5. Check for spring seated in recess of float.
538
Figure 15-5 Inspect Float Valve/Spring Assembly – Adjust If Required
11. Install the fuel bowl retaining screw and tighten it to 61 in-lb (6.9 N·m).
12. Write the size of the main jet on the fuel bowl with an indelible ink marker. This should be written in a location that
will be visible when the carburetor is installed on the engine.
13. Install the carburetor on the engine (Figure 15-1, Page 15-2) .
13.1. Attach the throttle return spring (11) to the carburetor and then to the throttle bracket (4) just before
positioning the carburetor and securing it to the engine (Figure 15-1, Page 15-2) .
13.2. Install the intake pipe gasket (16) (check for proper orientation) and intake pipe (17).
13.3. Install the carburetor retaining nuts (19) and tighten them to 50 in-lb (5.7 N·m).
14. Connect fuel supply line (26) and tighten screw clamp to 9 in-lb (1.0 N·m) (Figure 15-1, Page 15-2) .
2009 FE 350 Maintenance and Service Supplement Page 15-5