Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 112 / 280

12
Starter/Generator ELECTRICAL COMPONENTS
BELT TENSION ADJUSTMENT
Belt tension should be checked periodically. If the belt slips when starter/generator motor operates, adjust belt
to correct tension.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section 10,
Page 10-2.
2. Remove the seat to access engine compartment.
3. Make sure the two pivot bolts (5) on the mounting bracket are finger tight. The carriage bolt (11) and hex nut (12)
are to be finger tight also
(Figure 12-13, Page 12-11) .
4. Push the starter/generator down so it is at the lowest point of its adjustment travel. With the starter/generator belt
in place around the drive clutch pulley, install the starter/generator belt (3) around the pulley (10) on the end
of the starter/generator.
5. Position a pry bar (13) between the top of the starter/generator mounting bracket (2) and the underside of the
starter/generator by passing the pry bar under the exhaust header.
6. While holding the pry bar, measure the belt tension using a Krikit ® gauge (1) (available at NAPA ® Auto Parts
stores), or equivalent. Proper tension for a new starter/generator belt should be 75 lb (101.7 N) or 45 lb (61
N) for an existing belt
(Figure 12-14, Page 12-11) .
7. While maintaining the tension, tighten the adjustment nut (12) to 144 in-lb (16.3 N·m). Tighten the two pivot bolts
(5) and hex nuts (7) to 23 ft-lb (31.2 N·m)
(Figure 12-13, Page 12-11) . See following CAUTION.
CAUTION
• Remove pry bar before starting engine.
8. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
Page 12-12 2009 FE 350 Maintenance and Service Supplement