Single Point Watering System (SPWS)
CAUTION
• Water the batteries only AFTER charging.
• Use only the water deionizer equipment (CC P/N AM1240701) to water batteries with the SPWS.
WATERING BATTERIES WITH THE SPWS
Checking the Water Flow Rate
1.
Connect the water hose with the built-in screen filter (2) to the water faucet (1)
(Figure 26)
.
See following
CAUTION.
CAUTION
• Make sure the screen filter is clean.
• Do not use a longer garden hose than provided with the System (20 feet), as a decrease in water
pressure could overfill the batteries and damage the refill system.
2.
Before screwing the hose-end assembly (3) onto the opposite end of the water hose, check the screen filter (4)
inside the end of the assembly to make sure it is clean
(Figure 26)
.
3.
Connect the purger (5) to the female coupler (8) on the end of the hose-end assembly
(Figure 27)
.
1
2
3
5
4
5
7
6
8
3
68
Figure 26
Connecting Hose with Filter to Water Source
69
Figure 27
Checking the Water Flow Rate
4.
Completely open the water faucet until the water flows out of the hose-end assembly (3), and note the movement
of the red flow indicator balls (6).
See following NOTE
.
NOTE:
The water flow rate must be at least two gallons-per-minute for the SPWS to function properly.
This step also eliminates any trapped air from the water hose.
5.
Check the water quality light on the deionizer to make sure the light is green in color, indicating acceptable water
quality. If the light indicates unacceptable water quality, the cartridge must be replaced.
6.
After ensuring adequate water flow rate, press the grey button (7) on the end of the female coupler (8) to
disconnect the purger from the pressure regulator.
Page 46
DS Golf Car Owner’s Manual
Содержание DS Golf Car
