Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 375 / 536

UNITIZED TRANSAXLE: DASH-MOUNTED
SHIFTER Unitized Transaxle Installation
20
20. Install three wire ties to secure the engine kill wire to the accelerator cable where they both route together on the
passenger side of the engine.
571
Figure 20-42 Shock Absorber
569
Figure 20-43 Ignition Kill Wire
21. Connect the oil level sensor wire (18-gauge yellow) to the jumper wire (Figure 20-44, Page 20-17) .
22. Connect the 6-gauge white wire to the F2 post, the 6-gauge black ground wire to the A2 post and tighten both
wires to 48 in-lb (5.4 N·m). Connect the 16-gauge yellow wire to the DF post on the starter/generator and tighten
to 30 in-lb (3.4 N·m)
(Figure 20-45, Page 20-17) .
DF
F2
1
2
3
1. Yellow Wire 2. White Wire 3. Ground Wire at A2 Terminal
568
Figure 20-44 Oil Level Sensor Jumper wire
836
Figure 20-45 Starter/Generator
23. Position the shifter cable in the shifter cable mounting bracket on the engine and tighten the mounting nuts to 22
ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm (Figure 20-46, Page 20-18) .
24. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in-lb
(5.7 N·m) (Figure 20-47, Page 20-18) .
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 20-17