www.cls-led.com
CLS PiXelbar 36
- 3 -
- 4 -
Protection from burns and fire
• Provide a clearance of at least 50 mm around the unit.
• Do not install the CLS PiXelbar 36 near a heat source.
• Do not install the CLS PiXelbar 36 in a corrosive, flammable or explosive area.
• Do not modify the CLS PiXelbar 36, or install other than genuine parts.
• Do not operate the unit if the ambient temperature exceeds 40°C.
• Operate in a well ventilated area.
Protection from injury due to falls
• Verify that all covers and mounting hardware is securely fastened.
• Block the access below the work area whenever installing or removing the unit.
SAFETY INFORMATION
Warning! This product is for professional use only.
Read this manual before powering up or installing the CLS PiXelbar 36. Follow the instructions
listed below and observe all warnings in this manual.
Protection from electric shock
• Disconnect the power supply from AC power before installing, dismounting or maintaining the unit.
• Make sure all connectors are connected properly.
• Use only a source of AC power that complies with local building and electrical codes.
• Do not expose the unit to rain or moisture.
• Refer all service to a qualified technician.
OPERATION DETERMINATIONS
The CLS PiXelbar 36 is made for indoor use only. If the unit has been exposed to drastic temperature
changes, do not switch it on immediately. The arising condensation might damage your unit. Leave the unit
switched off till it has reached room temperature.
Only operate the unit after having checked the housing. Make sure it is firmly closed and the screws fastened
tightly. Do not shake the CLS PiXelbar 36. Avoid brute force when installing or operating the CLS PiXelbar 36.
Operate the CLS PiXelbar 36 only after having familiarized with its functions. Do not permit operation by
persons who are not qualified for operating the CLS PiXelbar 36. Most damages are the result of
unprofessional operation!
The maximum ambient temperature of 40 degrees must never be exceeded.
Please consider that unauthorized modifications on the CLS PiXelbar 36 are forbidden due to safety reasons!
INSTALLATION
Unplug from the mains before installation. Mount the brackets on the fixture. Connect the AC power cord
to the socket.
Dimensions
Wiring diagram
AC input10
0V~240V
50/60Hz
AC input10
0V~240V
50/60Hz
DMX Contro
ller
DMX OU
T DMX IN
DMX IN
