Cloud PM-8SA, Инструкция по установке и эксплуатации

Страница: 17 / 56

PM4/8/12/16 & PM4/8-SA Installation and User Guide v1.1
17
Paging all zones
1. Press and hold the CALL ALL button; all the LEDs for enabled zones and the
BUSY LED will illuminate.
2. Make the announcement.
3. Zones may be selected/deselected during the announcement.
4.
When the announcement is finished, release the CALL ALL button.
Sending a pre-recorded message to one or
more zones
1. Press the ZONE button(s) for the zone(s) to which the message is to be sent;
the LEDs corresponding to the selection will illuminate. (An incorrect selection
may be cancelled with the CLEAR button.)
2. Press the MESSAGE button for the required pre-recorded message; the
associated LED will illuminate to confirm selection.
3. To broadcast the message, press and release the TALK/SEND button. The BUSY
LED will illuminate for the duration of the message.
4. Zones may be selected/deselected during the message.
NOTE: Once the message is finished, the zone and message selections may either clear
or remain set for further use, depending how the unit was configured at installation. If
they remain set, they may be cleared by pressing the CLEAR button.
NOTE: The microphone is disabled for the duration of a pre-recorded message, so you
cannot make an announcement at the same time as broadcasting a message.
Sending a pre-recorded message to all zones
1. Press the MESSAGE button for the required pre-recorded message; the
associated LED will illuminate to confirm selection.
2. To broadcast the message, press and release the CALL ALL button; the LEDs for
enabled zones and the BUSY LED will illuminate.
3. Zones may be selected/deselected during the message.
4.
When the announcement is finished, the BUSY LED will go out.