Cloud 46 INTEGRATED, Руководство по установке и настройке

Страница: 18 / 24

46/50 Integrated Mixer Amplifier Setup And Installation Guide
CLOUD ELECTRONICS LIMITED
13 Active Speaker Equalisation Modules
Each output channel has the facility to connect a plug-in, speaker equaliser module. See the table below
for details of the connector for each output and the respective bypass jumper.
Installation:
1. Switch off the mains supply and remove the 46/50’s power lead.
2. Remove the unit’s top panel
3. Remove bypass jumper (see table below for jumper map). We advise that when
removing a jumper link, the connector remain attached to one pin of the header. This
prevents loss of the link.
4. Fit the EQ module card to the connector. The EQ card should be perpendicular
to the main board.
5. Apply moderate pressure to the EQ module until it locates with a click.
6. Replace the top panel.
NOTE: We advise that when you remove a jumper you leave it connected to one pin of the header so it
remains with the apparatus for future use.
When setting the jumper(s) please ensure that you:
• Remove the mains cable from the rear of the product before removing the top panel.
• Only reassemble the unit using screws identical to the original parts.
14
V6 070113
Location of Jumpers J8 and J10
Location of Jumpers J17 and J19
Zone Connector Jumper
1 CON 3 J8
2 CON 4 J10
3 CON 7 J17
4 CON 8 J19