Cloud 46 INTEGRATED, Руководство по установке и настройке

Страница: 14 / 24

9 Zone 1 Facility Input
Zone 1 has a facility input; this 9 pin sub D connector provides
direct access to the zone and is primarily used to connect one of
the dedicated active remote input modules such as the DM-1 or
LM-1. An active module can extend the facilities of the 46/50 by
providing local zone access and control remotely. (See section
11 for more details on active modules).
10 Power Supply Capacity
The power supply of the 46/50 has an external load capacity of 80mA. Care should be taken when wiring
or connecting modules and external devices to the 46/50 since exceeding the external load capacity risks
temporary power supply failure. The table below lists the current consumption of each compatible 46/50
module and external device. Use this table to verify that the external load of your proposed system falls
within the specified limits.
NOTE: If the 46/50 has a PM4 paging microphone installed, you have the option to power the microphone
with the 'CPM-PSU' external power supply. This will reduce the load on the system by 72mA. If a power
supply failure occurs switch off the 46/50 and disconnect the external devices, the 46/50 should be left
off for approximately 30 seconds to allow it to reset. Check the wiring and total current consumption of
the external active devices before reconnecting the power and if the problem persists contact our
technical department.
External Active Device / Internal Module Current Consumption
PM4 72mA
AE-1 9mA
DM-1 18mA
LM-1 12mA
BOSE EQ: M8, M32, MA12, 402, 502A, 802, MB4,
MB24, 502B, 502BEX
12mA
BOSE EQ: LT3202, LT4402, LT9402, LT9702 17mA
BOSE EQ: M16 34mA
46/50 Integrated Mixer Amplifier Setup And Installation Guide
CLOUD ELECTRONICS LIMITED
10
V6 070113
1 2 3 4 5
6 7 8 9
REMOTE
SOURCE
REMOTE
LEVEL
BALANCED INPUT
+ -
NOISE
GATE
NOISY
0V
-15V
+15V
0V
VCA CONTROL
VOLTAGE
Facility Input Pin Configuration