36-50 Installation and User Guide V1.0
6
SAFETY INFORMATION
Safety Notes regarding Installation
• Do not expose the unit to water or moisture.
• Do not expose the unit to naked flames.
• Do not block or restrict any air vent.
• Do not operate the unit in ambient temperatures above
35
°
C
• Do not touch any part or terminal carrying the hazardous
live symbol while power is supplied to the unit.
• Do not perform any internal adjustments unless you
are qualified to do so and fully understand the hazards
associated with mains-operated equipment.
• The unit has no user-serviceable parts. Refer servicing to
qualified service personnel.
• If the moulded plug is cut off the AC power lead for
any reason, the discarded plug is a potential hazard and
should be disposed of in a responsible manner.
Conformities
This product conforms to the following European EMC
Standards:
BS EN 55103-1:2009
BS EN 55103-2:2009
This product has been tested for use in commercial and
light industrial environments. If the unit is used in controlled
EMC environments, the urban outdoors, heavy industrial
environments or close to railways, transmitters, overhead
power lines, etc., the performance of the unit may be degraded.
The product conforms to the following European electrical
safety standard:
BS EN 60065:2012
Safety Considerations and
Information
The Cloud 36-50 must be earthed. Ensure that the mains
power supply provides an effective earth connection using a
three-wire termination.
Caution – High Voltage
Do not touch any part or terminal carrying the hazardous live
symbol
while power is applied to the unit. Terminals to
which the hazardous live symbol refers require installation by
a qualified person.
Caution – Mains Fuse
The 36-50 contains no user-replaceable fuses. Mains over-
current protection is provided by the fuse in the IEC
receptacle; only replace this fuse with one of an identical
type and rating. If the replacement fuse blows immediately it
indicates that the mixing amplifier has developed a fault, which
should be referred to competent service personnel.
Caution – Servicing
The unit contains no user-serviceable parts. Refer servicing to
qualified personnel. Do not perform servicing unless you are
qualified to do so. Disconnect the power cable from the unit
before removing the top panel and do not make any internal
adjustments with the unit switched on. Only reassemble the
unit using bolts/screws identical to the original parts.
