Cloos qineo PULSE MASTER-Plus, Руководство по эксплуатации

Страница: 29 / 44

29
3.2.4 Control voltage mode
Control voltages are analogue DC voltages from 0 … 10 Volt. They serve to
control the parameters Power, ArcLength and ArcDynamic (dynamics) in
the QINEO.
Via an input-output-module (I/O module) the control voltages are passed
on to the welding power source, for instance by a robot control.
The control voltage operation is switched off if the number of control
voltages is 0. You can select 2 or 3 control voltages. The control voltage is
selected by means of the rotary knob.
3.2.5 External selection of process
Pertains to I/O module, all field bus modules and robot connections.
Function Description
On
The three input signals for pulse, pulse I/I and Cold Weld are
taken into consideration when switching the process.
Off
The three input signals for pulse, pulse I/I and Cold Weld are
not taken into consideration when switching the process.
3.2.6 Reset to factory setting
Press and hold the knob to reset the settings.
When resetting to the factory settings, all configuration points are reset to
the standard settings (default).
In addition, the no-job operation will be reset to the default values.
All saved jobs (1 through 999) and the characteristic curves are not
changed.
In addition, the configurations for the VBC module (including IO module)
are not changed.
3.3 General configuration
3.3.1 Automatic Hold display
If the automatic hold function is activated, after the welding process,
the average value of the last welding seam is displayed for a period of 5
seconds.
NOTICE!