CLIVET WSAN-YES 18.2, Руководство по установке, использованию и обслуживанию

Страница: 52 / 66

52
WSAN-YES 18.2-35.2
M0ST10N19-00
intervention frequency (months) 3 6 12
1
presence corrosion
X
2
panel fixing
X
3
fan fixing
X
4
coil cleaning
X
5
water filter cleaning
X
6 water: quality, pH, glycol concentration X
7 exchanger efficiency check X
8 circulation pump X
9
check of the fixing and the insulation of the power lead
X
10
check of the earthing cable
X
11
electric panel cleaning
X
12
power remote controls status
X
13
termina closing, cable insulation integrity
X
14
voltage and phase unbalancing (no load and on-load)
X
15
absorptions of the single electrical loads
X
16
compressor casing heaters test
X
17
Checking for leaks*
*
18 survey of the refrigerant circuit operating parameters X
19 safety valve* *
20 protective device test: pressure switches, thermostats, flow switches etc.. X
21
control system test: setpoint, climatic compensations, capacity stepping, water / air flow-rate
variations
X
22
control device test: alarm signalling, thermometers, probes, pressure gauges etc..
X
* Refer to the local regulations
.
10 MAINTENANCE
Inspections frequenty
Perform an inspection every 6 months minimum.
The frequency, however, depends on the use.
In the event of frequent use it is recommended to
plan inspections at shorter intervals:
 frequent use (continuous or very intermittent
use, near the operating limits, etc)

critical use (service necessary)
 in highly aggressive environments such as
 industrial environments with concentrations
of combustion fumes or chemical
substances

highly polluted urban environments

rural areas with concentrations of
fertilizers, livestock manure, diesel engine
exhaust gases

coastal areas