CLIVET MSAN-XMi 120T, Инструкция по установке и эксплуатации, Страница: 74 / 92

Fig.5-6
D
$
/
/
%
&
'
(
/ / /
E
F
G H I
The first connecting methond
Outdoor unit
Pipe length(From the nearest branch pipe equivalent length)
Drop HEIGHT
between indoor unit
and uutdoor unit
The first manifold
Maximum pipe equivalent length
(From the first line branch pipe) Maximum pipe equivalent length
Indoor Unit to Indoor Unit Drop Heihgt
Indoor Unit
Fig.5-7
D
1
1
1
1
1
1
$
%
'
(
&
E
F
H
I
G
/
/
/
/
/
The second connecting methond
Outdoor unit
Drop HEIGHT
between indoor unit
and uutdoor unit
Indoor unit farthest pipe equivalent
length
The First manifold
Pipe length(From the nearest manifold
equivalent length)
(From the first manifold)
Maximum pipe equivalent length
Indoor Unit to Indoor Unit Drop Heihgt
Indoor unit
5.6 Remove Dirt or Water in the Pipe
1. Make sure there is no any dirt or water before connecting the
pipe to the outdoor units.
2. Wash the pipe with high pressure nitrogen, never use
refrigerant of outdoor unit.
5.7 Airtight Test
1. Connect the high pressure side pipe and liquid side stop valve
after connecting indoor unit pipes.
2. Weld low pressure side pipe and meter connector.
3. Use vacuum pump to discharge air from valve core of liquid
side stop valve and meter connector until the pressure reaches
to -1kgf/cm
2
.
4. Close the vacuum pump and fill nitrogen40kgf/cm
2
.
5. At the end of air tightness test, the gas side stop valve and
the low pressure side piping should be welded.
Fig.5-8
Liquid side stop valve
Gas side stop valve
Nitrogen
Nitrogen
Liquid pipe
Gas pipe
Indoor unit
Meter connector components
used for pressure bulge test
06$1;0L77 ,QVWDOODWLRQPDQXDO