CLIVET CN-XMi D112, Инструкция по установке и эксплуатации

Страница: 36 / 68

Water Pump Box (SBH-05) Installation Guide
Heat-insulating material
0.8m~1.0m
Downward sloping
over 1/100
Water Pump Box Constitutional Diagram
Name
Water Pump Box Installation Schematic Diagram Installation Guide
Drain Pipe Connecting Installation Schematic Diagram
1
Wire through hole
Outlet pipe interface
Lifting lug
Inlet pipe interface
Branch line (Product accessories)
Nut (Product accessories)
2
2
3
8
6
7
8
4
1 The box installation should be same as the
diagram , and the box must be installed
horizonally.
2 the height of indoor unit should be equal to (or
higher )the pump box's to ensure the drainage
water flow into the pump box. And then fasten
the nuts to fix the pump box.
3 The PVC connection pipe is recommended, the
connection pipe should be good insulation to
avoid the condensate water on the surface. The
thickness of the insulation material should be
least 8mm.
4 There are 4 gruop cables in the box, two group
cables are used to drive the pump, one group
cable is used for the water level sensor , one
group cable is connect with the earth.
5 The pump cables should be connected to the
"PUMP" port on the indoor unit PCB .
Noted: If there are 4 PCBs in the indoor unit
control box , connect with any 2 PCBs is ok.
6 The ground wire should be connected to indoor
unit's earth wiring terminal.
7 The water level sensor wire should be
connected with the branch line firstly , and then
connect to the "water " port on the indoor unit
PCB .
Noted : For the units with 2PCB , any 2 cables
should be connected .The other two cables
should be fixed on the box .
8 When it needs maintenace or clean ,it is not
necessary to disconnect all the ducts and wires.
you can only remove the maintenace
screws (
each hanger rod side has 2
screws) to do the
maintenace or clean the inner parts.
Support the
device
Drain pipe
5
Maintenance screw(4 pieces)
a
b
Stype
Bend
Drain pipe Set to be U-shape
For avoiding backflow
Drain pipe and its connector
Make sure to be wrapped well by
the thermal insulation pipe
For avoiding condensation
Indoor unit
Water pump box
W
ater outlet pipe
150~250mm
”PP
Water inlet pipe
To maintain the level of installation
To maintain the level of installation
Pump 1
Pump 2
Ground
Water level sensor
Branch line
(Product accessories)
Nut
(Product accessories)
Washer
(Product accessories)
Hanger rod
1
2
3
4
5
3
Nut 1
Washer 1
Washer 2
Nut 2
6
7
8
Washer (Product accessories)
OD 32 / ID 27.5
OD 32 / ID 27.5
Unit :mm
16010700000064 V1.0
&1;0L''