Clipper Jumbo 1000 P13, Руководство по эксплуатации

Страница: 11 / 24

11
3 Assembly and commissioning
The machine is delivered fully equipped and assembled and is ready for operation after connection
to the appropriate power supply.
3.1 Tool assembly
Use only NORTON blades with a maximum diameter of 1000 mm on the Jumbo 1000 P13.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine’s maximum permitted rotation speed.
Switch off the engine before mounting a new blade into the machine.
To mount a new blade, follow these steps:
•
Disconnect water hoses from the blade guard.
•
Retract outside cover of blade guard.
•
Loosen the hexagonal nut on the blade shaft while holding the shaft (with the two 36mm
spanners supplied with the machine), which holds the removable outer flange.
•
Remove the outer flange.
•
Clean the flanges and blade shaft and inspect for wear.
•
Mount the blade on arbour ensuring that direction of rotation is correct. Wrong direction of
rotation blunts the blade quickly.
•
Replace outer blade flange.
•
Tighten hexagonal nut while holding the shaft with spanners supplied for this purpose.
•
Shut retractable blade guard cover and reconnect water hoses.
ATTENTION: The blade bore must correspond exactly to the diameter of the blade shaft. Cracked
or damaged bore is dangerous for the operator and for the machine.