17
iv.
Verify that the GC25E UP power switch in the “OFF” position.
v.
Connect the extension cord set to the machine and power supply.
Follow all local and national electrical code. If unsure of how to
connect the extension cord set or of the electrical circuit have a
qualified Electrician make all electrical connections.
vi.
Move the start switch to the “ON” position and the motor should
start. If the motor doe not start have a qualified Electrician inspect
all electrical connections and the power supply.
6. To set the Depth Gauge:
a. Slowly lower the Blade by rotating the Hand Wheel clockwise until the
Blade touches the work surface.
b. Loosen the Depth Gauge Thumb Screw.
c. Move the Depth Gauge to the “0” position. NOTE: When using smaller
diameter blades it may be necessary to align the Depth Gauge to the “1”
mark.
d. Tighten the Depth Gauge Thumb Screw.
e. Lower the machine by slowly rotating the Raise Lower Handle clockwise
until the desired depth of cut is reached.
7. Slowly lower the blade by rotating the hand wheel clockwise until the desired
depth of cut is reached. Use a reasonable rate of feed. Do not force the
blade into the cut!! If the engine starts to die slow down the rate of feed! If
the machine tries to climb out of the cut, slow down the rate of feed.
8. Adjusting the Dust Bellows: NOTE: Normally when the Dust Bellow is set for
the day there is no reason to readjust unless the blade has been removed or
the cutting depth has changed.
a. Turn the machine “OFF”.
b. Disconnect the Power Supply
c. Verify that the blade is properly installed.
d. Verify that the Blade Cover is closed and that the Blade Cover Thumb
Screw is tightened.
e. Loose the Dust Bellow front and rear Thumb Screw.
f. Lower the Dust Bellow until it touches the ground. NOTE: If the work
surface is uneven or has derbies the Bellow bottom surface can be
position 1/8” above the work surface.
g. Verify that the bottom edge of the Dust Bellows is parallel to the work
surface.
h. Tighten the front and rear Dust Bellow Thumb Screw.
