Clipper C1316SM, Руководство пользователя

Страница: 18 / 50

18
Engine and Blade Speed Chart
Blade
Diameter
Engine
RPM
Engine
Pulley
Diameter
Blade
Shaft RPM
Blade Shaft
Pulley
Diameter
14"
(356mm) 3600 RPM 3.15" (80mm) 2520 RPM
4.5"
(114mm)
16"
(406mm) 3600 RPM 3.15" (80mm) 2520 RPM
4.5"
(114mm)
20"
(508mm) 3600 RPM 3.15" (80mm) 2520 RPM
4.5"
(114mm)
24"
(609mm) 3600 RPM 2.65" (67mm) 2120 RPM
4.5"
(114mm)
10. Slowly lower the blade by rotating the hand wheel clockwise until the
desired depth of cut is reached. Use a reasonable rate of feed. A
reasonable rate of feed will depend on depth of cut, material, and blade.
Normal cutting speeds should be between 2 ft/min in very hard material
and up to 10 ft/min in softer materials. Do not force the blade in to the
cut! If the engine begins to stall or the saw raises out of the cut slow the
forward speed down!
11. For Self-propelled models move the Transmission Engage/Disengage
lever fully to the engage position and then slowly push the Speed Control
forward until the desired speed is reached. If the engine begins to stall or
the saw raises out of the cut slow the forward speed down! The further
the lever is pushed the fast the saw will move.
12. When the end of the cut is reached, slowly raise the blade out of the cut
by rotating the Hand Wheel Clockwise until the blade is at least one (1)
inch above the ground.
13. To place the machine in reverse: move the Speed Control lever towards
the back of the machine. Only move the saw in reverse with the blade in
the raise position. Always place the speed control back in the neutral
position after moving the saw.
14. When moving the saw to a new location be sure that the blade is not
touching the ground and always pay close attention to where you are
moving and where the blade is at all times.
15. To disengage the transmission, place the Speed Control in the Neutral
position and then slide the Transmission Engage/Disengage lever fully to
the “Disengage” position.