
Connection and printing
103932_ia_00
PHOENIX CONTACT
2-3
EnglishEnglish
2.3
Setting up the THERMOMARK S1.1
Select installation location
Place the THERMOMARK S1.1 on a level, stable surface. The room must be dry, free of
frost, and well-ventilated.
2.4
Configuring the printer
When connecting the printer for the first time, proceed as follows:
1
Load ink ribbon and materials
2
Connect the printer to the mains
3
Switch on the computer
4
Switch on the printer
5
Connect the printer to the computer
6
Install drivers
7
Add the printer to the marking software
The following describes each individual step in detail.
NOTE: The device and the print media can be damaged by humidity and water.
The THERMOMARK S1.1 may only be set up in a dry location protected from spray.
The following are not suitable:
–
Damp or dusty locations
–
Environments that are subject to increased heat, direct sunlight or low temperatures
(operating range: +5 °C to +40 °C).
Содержание THERMOMARK S1.1
