f. POS. EOC (Position End of Cycle)
Sets the needle position at the end of the cycle.
Default: Up
g. VENTURI
This parameter sets how the chain cutter can be turned on if a cut was missed at the
end of a cycle. If set to "heel bck" the cutter will start by heeling back on the treadle.
If set to "with eye" the cutter will start by breaking the beam of the electric eye.
Default: With eye
B. HIDDEN PARAMETERS
1. **** SPEEDS
a. TRIM / POS
This parameter determines the speed of the trim and position cycle and the minimum
speed of the machine.
Range: 100 to 400 s.p.m.
Steps: 10 s.p.m.
Default: 220 s.p.m.
b. MAXIMUM (Maximum speed). Sets the maximum speed of the machine.
Range: 500 to 9900 r.p.m.
Steps: 1000 r.p.m.
Default: 4200 r.p.m.
2. **** MISCEL (Miscellaneous)
a. NEED.dwn (Needle down)
Sets the needle down position. (See TEACH-IN MODE page 3-1)
Range: 0 to 255
Steps: 1
Default: 35
b.
NEEDLEup (Needle up)
Sets the needle up position. (See TEACH-IN MODE page 3-1)
Range: 0 to 255
Steps: 1
Default: 150
c.
CLAMP DTY (Clamp duty cycle or percentage of current applied to keep the solenoid
energized). The clamp duty cycle should be set at the minimum value required to keep
the solenoid energized. (a) If the duty cycle value is to low the solenoid will vibrate
(this will cause it to make a chattering noise) and the clamp may drop. (b) If the clamp
duty cycle value is to high the solenoid may get hot and the denergize time will greatly
increase.
Range: 2 to 10
Steps: 1
Default: 4
2-3
ML990-6
