Clinton 870LCD, Руководство по обслуживанию

Страница: 5 / 20

C. SYNCHRONIZER
Two methods are used to attach the synchronizer to the handwheel. They are (1) handwheel turned down to
accept synchronizer and (2) an adapter that is mounted to a machined handwheel.
Refer to figure 2-2 and install the synchronizer as follows:
SYNCHRONIZER INSTALLATION
UNIVERSAL MOUNT
FIG. 2-2
1. Install adapter if used.
2. Mount and secure synchronizer to handwheel or adapter.
3. Position the synchronizer retaining rod and clamp as shown in figure 2-2. Make sure that the rod
clears the sewing machine belt.
4. Using the mounting clamp hole as a guide, drill and tap a 10-32 hole in the machine casting. Secure
clamp and rod with a 10-32 X 1/2 B.H.M.S.
5. Drill a 1-1/4" Dia. hole in table to route synchronizer cable to logic box. Check that cable has adequate
slack when tilting machine for service.
D. LCD DISPLAY
Mount the LCD display console at a
convenient location on the table top
as shown in figure 2-3. Route cable
through same hole that synchronizer
cable passes through.
E. SWITCH BOX
Install switch box at a convenient
location under the table.
See figure 2-4.
2-2
ML890-8A
®
FIG. 2-3
FIG. 2-4