Clinch Rivets CR-2, Инструкция по эксплуатации

Страница: 9 / 11

Page 9 of 11
Head Cleaning and Oiling:
Every 10,000 cycles the tool should be oil on the jaws. (See figure 5)
1. Disconnect air supply and air valve switch.
2. Dismantle the riveter head by wrench.
3. Use wrench to disassemble head components and cleaning these parts, and then
lubricate them before assembling. (See figure 5)
Trouble Shooting
Symptoms Possible Causes Solutions
The jaws cannot release the
mandrel

The nosepiece, jaws, jaw
carrier and out cylinder
may not be assembled
correctly

The spring may be worn
out or broken

The oil may be insufficient

There is oil or air leakage
somewhere

Check the nosepiece,
jaws, jaw carrier and out
cylinder

Replace the defective
coupling and components

Add hydraulic oil
The rivet cannot be put into
the tool nosepiece

The stem may be
obstructed

The vacuum system may
not be in good condition

Check the jaws

Adjust the vacuum
security system to the
optimal volume
The tool works very slowly or
requires more than one
trigger-pull to set the rivet.

Hydraulic oil level is low

The air pressure is low

The nosepiece is filled
with dust and particles

Add hydraulic oil

Adjust air pressure to the
specific range

Clean and oil
Fig 5