Climette CA1516KR Скачать руководство пользователя страница 5

Страница: 5 / 32

TIPS BEFORE INSTALLATION

UNIT OPERATION HAZARD

Failure to follow this caution may result in damage to unit

components.
To avoid installation/operating difficulties, read the

instructions thoroughly.

CAUTION

Your Room Air Conditioner unit is designed to be highly

efficient and save energy. Follow these recommendations for
greater efficiency.

1. Select thermostat setting that suits your comfort needs and

leave the thermostat at that chosen setting.

2. The air filter is very efficient in removing airborne

particles. Keep the air filter clean. Typically, the filter

should be cleaned once a month. More frequent cleaning
may be necessary depending on outdoor and indoor air

quality.

3. Use drapes, curtains, or shades to keep direct sunlight

from heating your room, but DO NOT obstruct the air

conditioner. Allow air to circulate around the unit without
obstructions.

4. Start your air conditioner before outdoor air becomes

hot/cold and uncomfortable. This avoids an initial period
of discomfort while the unit is cooling or heating off the

room.

5. When outdoor temperature is cool enough, use HIGH or

LOW FAN only. This circulates indoor air, providing
some cooling comfort, and utilizes less electricity than
when operating on a cooling setting.

Your Room Air Conditioner was designed for easy installation in
a single or double--hung window.

NOTE

This unit is NOT designed for vertical (slider type)

windows.

POWER SUPPLY CORD

This room air conditioner is equipped with a protective power
supply cord that senses current leakage (see Fig. 3). Unit power is

automatically disconnected when unsafe conditions are detected.
To test the power supply cord:

1. Plug power supply cord into a grounded 3--prong outlet
2. Press RESET.
3. Press TEST (listen for click; RESET button will trip and

pop out).

4. Press and release RESET (listen for click; RESET button

will latch and remain in). The power supply cord is ready
for operation.

The Reset button must be pushed in for proper operation.
The power supply cord must be replaced if the RESET button

fails to trip when the test button is pressed or fails to reset. A

damaged power supply cord must be replaced with a new power
supply cord obtained from the product manufacturer. The

damaged cord MUST NOT be repaired.
Do not use the power supply cord as an off/on switch. The power

supply cord is designed as a protective device.
The power supply cord contains no serviceable parts. Opening
the tamper--resistant case voids all warranty and performance

claims.

TEST

RESET

A06531

Fig. 3

---

Power Supply Cord

NOTE

: Save the shipping carton and packing materials for

future storage or transport of the unit. Please check the contents
of the hardware kit against the corresponding model check list,
prior to installation of the unit. See lists below in Fig. 4.

3/4”Screws (10)

Top Channel(1)

End Cap &

Leveling Legs(2)

Bottom Channel(1)

or 10K to 12K models

)

Lock Washers(4)

1/4” Nuts(4)

Mounting

Brackets(2)

Angle