11
MASONRY CONSTRUCTION
The air conditioner is installed the same way as the
Wall Installation section with a few exceptions. Follow
all local and national building codes.
The cabinet can be secured to the masonry by using
masonry nail or masonry anchor screws.
Another installation technique would be to construct a
frame of 2 x 4s and install the frame between the wall
opening and the cabinet. The frame must be securely
anchored to the masonry wall opening.
Use a lintel to support masonry above wall opening.
Install exterior cabinet support brackets.
OPERATION
An electronic-type control is used on your Climette air
conditioner.
The electronic control consists of a control panel and a
remote control. Both the control panel or the remote
control can be used to set cooling and fan modes and
adjust the desired temperature. See Fig. 25. Other
additional features are provided.
REMOTE CONTROL AND
PANEL CONTROLS
Either the remote control or the control panel on the
air conditioner can be used. The battery of the remote
control will need to be installed before it can be used.
■
TURN UNIT OFF/ON —
Press the ON/OFF button
on the remote control or control panel.
NOTE: To switch from Celsius to Fahrenheit, press the
UP ARROW and DOWN ARROW buttons on the con-
trol panel (not the remote control) at the same time.
■
COOLING MODES —
The air conditioner can be
set to three different cooling modes — Cooling, Fan
Only, or Energy Saving. Press the MODE button to
select the cooling mode.
In Cooling mode, the air conditioner will run and pro-
vide cooling. The amount of cooling can be adjusted
with the FAN SPEED button. If the fan speed is set to
Auto mode, the fan speed adjusts automatically from
low to high based on the setting of the thermostat and
the actual room temperature.
In Fan Only mode, the fan operates to circulate the air
in the room, but there is no cooling operation. This
mode is used to circulate the air in the room when
cooling is not required. The amount of circulation can
be adjusted with the FAN SPEED button. Auto cannot
be selected in Fan Only mode.
In Energy Saving mode, the air conditioner will auto-
matically switch from cooling to fan only mode when
cooling is not required. Fan speed can be selected
in Energy Saving mode. When the room temperature
is 2 degrees higher than the thermostat setting, the air
conditioner will run in cooling mode. When the room
temperature is lower than 66 F, the unit will turn off
(no cooling or fan). At all other times, cooling will be off
and the fan will run on Low speed.
■
FAN SPEED —
The air conditioner Fan mode can be
set to High, Medium, Low, or Auto. Press the FAN
SPEED button to select the fan speed.
High fan mode is recommended for very warm days or
when a fast initial cooling of the room is desired.
Medium fan mode is recommended on moderately warm
days or when the unit has been operating for some time
and the temperature is about to reach its desired set-
ting. Low fan mode is recommended on slightly warm
days or after the room temperature has reached its
desired setting. Auto mode adjusts the fan speed auto-
matically from low to high based on the setting of the
thermostat and the actual room temperature.
■
THERMOSTAT —
The temperature setting on the
thermostat can be adjusted from a range of 66 to 88 F
(19 to 31 C). The air conditioner will start and stop
cooling operation in order to maintain the temperature
setting of the thermostat.
Press the Down Arrow button to lower the tempera-
ture setting. Press the Up Arrow button to raise the
temperature setting.
FIGURE 23 — SECURING BOTTOM RAIL OF
CABINET
FIGURE 24 — SECURING CABINET
TO FRAME
