4
Installation
z
z
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
G
G
u
u
i
i
d
d
e
e
l
l
i
i
n
n
e
e
z
The PIR Camera is designed to be mounted on either a flat
surface or in a corner situation with fixing screws and plugs
provided.
z
The base has knockouts, where the plastic is thinner, for
mounting purpose. two knockouts are for surface fixing and
four knockouts are for corner fixing as shown in the picture
z
It is recommended to install the PIR Camera in the
following locations.
z
Mount where the animals cannot come to the detection area by climbing on furniture or
other objects.
z
Don’t aim the detector at stairways the animals can climb on.
z
In a position such that an intruder would normally move across the PIR’s field of view.
z
Between 1.9 and 2m above ground for best performance. When mounted at 1.9 meters
above ground, it gives a typical PET IMMUNE range of 7 meters. As the PIR
Pet-Immune Camera is higher from above ground, it gives a farther PET IMMUNE
range.
z
In a corner to give the widest view.
z
Where its field of view will not be obstructed e.g. by curtains, ornaments etc.
z
For a small 3 to 5m room, install between 1.9 to 2m above ground.
z
Limitations
z
Do not position a PIR Camera to look directly at a door protected by a Door Contact,
this could cause the Door Contact and PIR Camera radio signals to be transmitted at
the same instant when entering, canceling each other out.
z
Do not install the PIR Camera completely exposed to direct sunlight.
z
Avoid installing the PIR Camera in areas where devices may cause rapid change of
temperature in the detection area, i.e. air conditioner, heaters, etc.
z
Avoid large obstacles in the detection area.
z
Not pointing directly at sources of heat e.g. Fires or boilers, and not above radiators.
z
Avoid moving objects in the detection area i.e. curtain, wall hanging etc.
z
z
U
U
s
s
i
i
n
n
g
g
P
P
I
I
R
R
C
C
a
a
m
m
e
e
r
r
a
a
w
w
i
i
t
t
h
h
Z
Z
i
i
g
g
B
B
e
e
e
e
R
R
o
o
u
u
t
t
e
e
r
r
IMPORTANT NOTE
If PIR Camera installation location is away from your system control panel and requires ZigBee
routers to improve signal strength.
DO NOT
use a ZigBee Router without backup battery. A ZigBee
router without battery will be powered down during AC power failure and the PIR Camera
connected to the router will lose connection with ZigBee network. Plan your PIR Camera
installation location using only ZigBee router with backup battery.
z
z
M
M
o
o
u
u
n
n
t
t
i
i
n
n
g
g
t
t
h
h
e
e
P
P
I
I
R
R
C
C
a
a
m
m
e
e
r
r
a
a
z
Surface
mounting:
1. Remove the cover.
2. Depend on mounting location, Break through either the 2
Surface knockouts at the center, or the 4 Corner
knockouts on the edge of the back cover
3. Use the holes as template to drill holes on the mounting
location.
4. Insert the wall plugs if fixing it into plaster or brick.
5. Screw the base into the wall plugs.
6. Screw the cover back onto its base.