2
Control Panel will automatically turn the function back ON after the duration. The tamper detection can also be enabled again manually using
the Siren Tamper function.
Audio & Visual Status Indication
While arming / disarming the system, the BX-23 uses different methods to distinguish various statuses for the user, as listed in the table.
*
The Siren Audio indication will be affected by the Confirmation ON / OFF setting. When setting Confirmation to OFF, the confirmation sound
will not be available. Refer to Control Panel Siren setting for Confirmation function.
Getting Started
Learning
Step 1: Release the bottom screw of the Bellbox using a Philips screwdriver and remove the top
cover.
Step 2: Release the 4 screws securing the LED cover using a Philips screwdriver and remove
the LED cover.
Step 3: Put the Control Panel into learning mode (refer to Control Panel’s user manual for
details).
Step 4: Power up the Bellbox by sliding the power switch to BT4 position. All the LED will flash
once and the buzzer will emit 1 beep.
Step 5: Press the Learn button once. The Bellbox will emit a short beep and LED groups 1 & 3
will turn on briefly. The Bellbox is now in learning mode and will transmit a learning code
to the Control Panel.
Step 6: If the Control Panel did not receive a learning code, press the learn button again (the
Bellbox will not sound a beep this time).
Step 7: If the Control Panel receives the learning code, it will list the device information
accordingly, follow Control Panel manual instruction to complete the learning procedure.
An acknowledgement will be sent to the Bellbox. When the acknowledgment is received,
the Bellbox will sound two short beeps with LED group 2 flashing once to indicate that
learning process is successful. The Bellbox will then leave learning mode.
Step 8: Refer to the Control Panel manual and use Edit Device function to check Bellbox
settings. You can edit the operation area, zone number, and device name for the
Bellbox.
<NOTE>
If the learning process fails, please repeat steps 3-7 again.
If the bellbox does not receive the confirm code from the Control Panel within one
minute, the bellbox will leave learning mode and the LED groups 1 & 3 will turn off.
Edit Bellbox Operation Area
Follow instruction below to change Bellbox Operation Area in the Control Panel
Step 1: Use the panel Edit Device function to change Bellbox area setting.
Step 2: Press the learn button on the Bellbox to send signal to panel, the Bellbox will emit a beep and flash LED 1 & 3 once.
Step 3: When the Bellbox receives acknowledgement signal from panel, it will emit a beep and flash LED 2 once to indicate the setting has been
updated. The Bellbox will return to normal operation.
Installation
Proceed to installation after complete learning.
Step 1. Disable the Siren Tamper function on the Control Panel (please refer to the
Control Panel instruction manual). The bellbox will sound a beep to indicate the
tamper switch is now disabled.
<NOTE>
The function Siren Tamper will only be OFF for a duration of one hour. The
Control Panel will automatically turn the function back ON after the duration.
Siren Audio
Strobe light indication
Arm/Home
1 beep*
3 LED groups flash once
Disarm
2 beeps*
Sequentially flashes for 1 cycle
Arm (Low Battery)
3 beeps
3 LED groups flash for three times
Disarm (Low Battery)
3 beeps
Sequentially flashes for 3 cycles
Arm (Tamper)
5 beeps
3 LED groups flash for 5 times
Disarm (Tamper)
5 beeps
Sequentially flashes for 5 cycles
Entry/Exit Sound
Count-down beeps