Figure 18: Indoor Compressor Section Line Voltage Field Wiring
Unit Power Supply
(see electrical table for wire
and breaker size)
Electrical - Power Wiring
208-230 Volt Operation
Verify transformer tap with air handler wiring diagram to
insure that the transformer tap is set to the correct voltage,
208V or 230V.
Figure 19: Outdoor Compressor Section Line Voltage Field Wiring
ELECTRICAL - HWG WIRING
Figure 20: HWG Module Wiring - For Use with Outdoor Compressor Section
Consult Electrical Table for wire and fuse size.
All power wiring per local code
L2
L1
T2
T1
HWG Module Wiring - For “Outdoor” Compressor
Section
The HWG module should be wired to a 115 vac power
supply as shown in
¿
gure 20. A safety disconnect should be
installed at the HWG module as required by code to allow
servicing of the module. DO NOT energize the pump until all
HWG piping is completed and air is purged from the water
piping to avoid running the pump “dry”.
CONDENSER
CONDENSER
CONDENSER
HWG Module
R e s i d e n t i a l S p l i t U n i t s - 6 0 H z P u r o n
®
R e v. : 6 D e c . , 2 0 1 1
32
