3
For retrofitted to an existing heat pump
For new installation of heating pump
S t e p
B
– F i x i n g t h e p a n a d a p t e r
Before you place the drainage pan on the ground bracket/
wall attachment, fix the pan adapter in the pan.
It is IMPORTANT that the washer is on the TOP of the drainage
pan. Tighten the adapter with the locking screw.
S t e p
C
– A s s e m b l y o f t h e h e a t e d p a n
Place the pancake between the vibration dampers on the
stand with the pan adapter at the back and the cable to
the right.
The diagram shows the location of the drainage pan - do not screw the other
flat washers and nuts onto the vibration dampers before the pump is in place.
Before tightening nuts
3
and
4
, place the drainage pan
under the pump by slightly inclining the pump at the back
and in this way opening it up sufficiently with space to feed
in the pan from the front.
4
3
NB: Attach the extensions on the outside unit first!
OUTSIDE PART NOT SUFFICIENTLY DEEP?
Does your outside unit not have sufficient depth for there to be
space with the Pancake pan between the feet?
Then you need a set of extensions.
Attach them to the outside unit’s feet and then
screw them into the rear vibration dampers
so that sufficient space is created
for the Pancake drain pan.
